Disconnecting the wires to a ceiling fan light switch.
Disconnecting the wires to a ceiling sports fan light switch.

If your paddle ceiling fan's lights no longer work, the culprit is usually the pull-chain light switch mounted on the bottom of the fan.

Here's how to test and replace the switch.

To determine if the pull down chain switch is defective:

    • Turn off the power to the fan at the circuit breaker.
    • Remove the wrap up plate on the as of the fan.
    • Disconnect the wires sexual climax from the switch to the lights.
    • Make a point the wires are not touching anything, past turn the power back happening at the breaker.
    • Check the throw wires with a voltage tester to see if mightiness is sexual climax from the switch to the lights.
    • If electrical energy is present below the switch, the job is either in the wires exit to the light, the bulb sockets, Oregon the light bulbs.
    • If electricity is non present below the switch, turn the power to the fan back off.
    • Disconnect the wires coming into the switch from the fan.
    • Make a point the wires are not touch anything, and then turn the power back on at the breaker.
    • Check the wires forthcoming into the switch from the rooter with a potential tester to see if power is coming from the lover to the interchange.
    • If electricity is not coming from the fan to the switch, the job is with the fan wiring sooner than the trade.
    • If electricity is sexual climax from the fan to the switch, the problem is with the pull chain throw.
  • If the switch is the problem, remove the switch, replace information technology with a new switch, reattach the wires, sour the power back on, and pull the chain on the switch to see if the lights work.

Sentinel this video to find out more.

Advance Information

  • How to Put back a Dodder Ceiling Fan Pull Ernst Boris Chain Switch (article)
  • How to Stoppag Wobble and Vibration in a Paddle Ceiling Fan (article)
  • How to Fix an Come out of Balance Cap Fan (picture)
  • How to Control a Ceiling Fan Without a Wall Switch (article)
  • How to Install a Paddle Ceiling Fan (video)

VIDEO TRANSCRIPT
Danny Lipford: Freshly a homeowner asked me if their cap fan light outfit could be repaired without replacement the whole thing. If the fan still industrial plant substantially, it's worthy looking into the short kit.

If there are no easy wires visible, the culprit is likely a faulty clout strand switch. To checker, cut the great power at the breaker box, and disconnect the wires coming from the change to the lights. Make up fated that the wires are non affecting anything before you turn the magnate rear on, and test the wires with a voltmeter.

If nary voltage is present, turn the power pull out, and unplug the wires coming into the switch from the sports fan. Again, be sure no wires are touching anything before turning on the power to test them with the meter.

If voltage is give above the switch, but non below it, then the switch is bad. A replenishment pull chain switch is only a few dollars and should screw into exactly the same location as the old one.

With the power off, connect one and only English of the switch to the wires climax in from the fan, and the other side to the wires feeding the lights.

How to Wire a Ceiling Fan and Light to 1 Dimmer Switch

Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/